AIC3106 LINUX DRIVER

This page has been accessed , times. Performance benchmarks were collected using the Iperf tool and default options were used to collect the throughput numbers. This chapter describes the SPI flash driver architecture, driver features and performance numbers throughput and CPU load. These 3 components correspond to the 3 layers of ASoC mentioned in the overview section of the Sitara audio landing page. Please refer to hardware documentation for list of all supported boot modes.

Uploader: Bazuru
Date Added: 16 June 2004
File Size: 67.22 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 17808
Price: Free* [*Free Regsitration Required]

AMx devices provides a rich set of power management features. The MMC driver is implemented as a block driver. The commit for this change in Linux stable tree is a96e patch. Enable analog audio support” is included in the Linux 4. The I2C lijux is implemented as a serial driver.

AMx-PSP Features and Performance Guide – Texas Instruments Wiki

It also provides the typical power linuxx measurement observed for different scenarios. Performance benchmarks were collected using the Iperf tool and default options were used to collect the throughput numbers. On detailed information on specific features or limitations of a pariticular driver, refer to the chapter catering to that driver in this document. The commit for this change in Linux stable tree is c5dd patch.

  ASUS 138G DRIVER

[alsa-devel] AIC3106 problem with driver (MIC BIAS)

Enable pcf 0x26 address on i2c2 bus” is included in the Linux 4. Enable the system mailboxes 5 and 6″ is included in the Linux 4. From Texas Instruments Wiki.

Note that while many of these configurations are accomplished in the source code corresponding to each ASoC layer, some are also done the Device Tree. Storage gadget media file is created using the command:.

Measurements were taken while Linux was idle at command prompt. The measurements were done using EVM revision 1. AMx has a bit watchdog timer which can be used to reset the hardware in case of a software fault. Test setup is available here. Retrieved from ” http: Gets device parameters from the UART example, port type, port num, baud rate, base divisor, and so on. These 3 components correspond to the 3 layers of ASoC mentioned in the overview section of the Sitara audio landing page.

If you are a TI Employee and require Edit ability please contact x from the company directory. This section indicates the power measured for all power rails when system is in suspended state via suspend-to-ram. The cpuidle framework helps in saving power during the idle state. Total Power Sum of all Rails.

  GRIFFIN IMIC PC DRIVER

Linux Archives – Page of – Linux Kernels

The definition of idle at Linux prompt is as per the tables shown aic3160. Thus, overall SPI performance reported above ac3106 lower than what can be obtained using a 48 MHz clock. CAN driver supports transmitting and receiving in-order packets, processing happens at various bit rates. This page was last modified on 4 Mayat The commit for this change in Linux stable tree is de8b patch. Supports the system call support proivided by MTD interface viz.

CPU is not loaded evenly during execution. Hot plug scripts in the filesystem mount removable media in sync mode to ensure data integrity. A resistive touchscreen operates by applying a volatge across a resistive network and measuring the change in resistance at a given point on the matrix where the screen is touched by an input stylus or finger. Aix3106 from reset to “Login: